Lenze ApplicationTemplate PackML (PLC Designer R3-x) - Manual (Page 34)

Opening the ApplicationTemplate PackML
Updating the controller in the project (optional)
34
Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2 Updating the controller in the project (optional)
Cases in which the project must be updated
The controller in the »PLC Designer« must be updated if ...
• ...the project contains firmware information that is older than the hardware to be used or
• ...a controller other than the integrated 3200 C controller is desired (example: p500).
If the controller is marked with the icon after the project is opened, the device information of
the »PLC Designer« project have to be updated.
Determining the firmware of the controller

How to proceed:
• Use the »WebConfig« to check which firmware is used by the controller to select the
appropriate device information in the »PLC Designer«.
7.3 Going online
In order to be able to establish an online connection to the controller, the communication settings
(Set active path) must be commissioned before.  Setting up communication to the Controller
( 11)
7.3.1 Compiling the project data
To compile the project data, select the BuildBuild menu command or press the <F11> function
key.
• If errors occur during the compilation, they are to be localised on the basis of the »PLC Designer«
error messages and corrected correspondingly. Recompile the project data afterwards.
• If no errors occur during the compilation, the »PLC Designer« project must be saved:
File Save project
7.3.2 Transferring the project to the control - "Log in"
The desired project must be transferred to the PLC device by "Logging in" to the controller: Call menu
command Online Log in.
7.4 Downloading and starting the PLC program
• Load the PLC program to the controller: Call OnlineLoad menu command.

Note!
To "log in" the PLC program must be error-free. For this it must be possible to execute the
BuildBuild (F11) menu command without an error message.