Lenze ApplicationTemplate PackML (PLC Designer R3-x) - Manual (Page 41)

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
41
Working with the ApplicationTemplate PackML
Creating machine modules: Copy/insert machine module templates
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 Creating machine modules: Copy/insert machine module templates

Tip!
If individual machine modules are created, the ApplicationTemplate PackML automatically
assigns the corresponding machine module-internal names.
Creating machine modules: What has to be done?

How to proceed:
1. Copy the EmptyModule_PackML machine module template:
• Right-click the A66 EmptyModule_PackML\MM_EmptyModule_PackML folder 
Copy Empty Module.
2. Insert the previously copied machine module (MM_Empty Module_PackML) below the
A70_MachineModuleSources folder:
• Right-click the A70_MachineModuleSources  Insert Empty Module
3. Enter the desired module name.
The module name can be selected freely and …
• must not contain "MM_"
• may only contain the characters "A ... Z", "a ... z", "0 ... 9"
• must not contain any special characters.
4. Click Insert to insert the machine module.
• The machine module has been inserted with the applicable names of the MAPs/MFB,
structures, and visualization.
• The machine module is instanced with the previously assigned name.
5. The machine module inserted (MFB_*) is to be inserted in the MMT in the
A10_MachineModuleTree folder.  Integrating machine modules in the MMT
6. The module application (MAP_*) in the A11_ModuleAppCalls folder is to be inserted in
the desired module application call (MAC_Task_*).  Assigning the module application
(ModApp) to the task
The machine module template EmptyModule_PackML...
• ...has to be copied in the A66 EmptyModule_PackML
folder using the Copy Empty Module command and
• ...then using the Insert Empty Module command to
insert it into the A70_MachineModuleSources
folder.