MTS SWIFT 10 ATV Sensor - Manual (Page 53)

USB driver installation
SWIFT 10 ATV Sensors Setting up the Transducer Interface 53
4. On the next window, select the Install from a list or specific location
(Advanced) radio button.
5. If you copied the driver files from the CD to your hard drive, use the
browser to direct the wizard to the location where you copied the files as
shown in the next figure.
6. Click Next to install the loader for the MTS SWIFT TI Interface
7. When the installation is complete, click Finish on the window that displays.
8. Another Found New Hardware Wizard will display.
Repeat Steps 4 through 7 to install the MTS SWIFT TI Interface driver for
the TI Interface.
9. Restart your computer to activate the new settings.