MTS SWIFT 10 ATV Sensor User Manual
Page 68
SWIFT 10 ATV Sensors
68
Road and Track Vehicles
Installing the Transducer
6. Use the twenty M8 fasteners to attach the transducer and washer plate to the
modified wheel rim (see the previous table). Ensure the electrical
connectors on the transducer face away from the rim. Hand tighten the bolts.
If environmental conditions warrant, coat each fastener with Birchwood
Casey Sheath RB1 rust preventative (or equivalent).
Lubricate the threads and under the head of each fastener with Molykote g-n
paste.
Typical Wheel Assembly
7. Tighten the twenty M8 mounting bolts securing the transducer to the
modified rim.
A. Following the outer bolt pattern sequence shown in the figure on
, torque the twenty M8 bolts (1 through 20) to the value for the first
increment shown in the table on
B. Repeat Step 7A for the final increment.
8. Mount the wheel assembly.
With the wheel assembly against the inner hub adapter, position the slip ring
bracket, with the slip ring, against the transducer. Ensure the connectors
between the slip ring bracket and the transducer engage properly.
Vehicle
Spindle Hub
Inner Hub
Adapter
Lug Nuts
Modified Rim
Transducer
Washer
Plate
Slip Ring
Bracket
Slip Ring
S10-11