MTS SWIFT 10 ATV Sensor User Manual
Page 90
SWIFT 10 ATV Sensors
90
Road Simulator
Installing the Transducer
A. With the transducer and adapter plate assembly against the inner hub
adapter, position the slip ring bracket, with the slip ring, against the
transducer.
Ensure the connectors between the slip ring bracket and the transducer
engage properly.
Note
If the jack screws used to remove the slip ring bracket are still in the slip
ring bracket, remove them before continuing.
B. Use the eight M8 fasteners provided to attach the slip ring bracket to
the transducer and inner hub adapter. Hand tighten the bolts.
C. Lubricate the threads and under the head of each fastener with
Molykote g-n paste.
Bolt Torque Sequence
D. Following the inner bolt pattern sequence shown in the previous figure,
torque the eight M8 bolts (A through H) to the value for the first
increment shown in the following table.
E.
Repeat Step 6D for the second increment.
Note
To minimize negative clamping effects, you must torque the bolts in the
sequence shown in the figure above.
1
6
9
20
15
3
7
11
18
14
5
2
10
19
16
4
8
12
17
13
Inner Bolt
Pattern
Outer Bolt
Pattern
S10-12
E
H
D
B
F
G
A
C
Jack Screw
Holes
T
ORQUE
I
NCREMENT
M8 B
OLT
S
IZE
M10 B
OLT
S
IZE
1st Increment
19
N•m
(14 lbf•
ft)
26
N•m
(19 lbf•
ft)
Final Increment
38
N•m
(28 lbf•
ft)
53
N•m
(39 lbf•
ft)