MTS SWIFT 10 ATV Sensor - Manual (Page 73)

Road and Track Vehicles
SWIFT 10 ATV Sensors Installing the Transducer 73
D. Attach the transducer output cable to the slip ring encoder connector
and the J3 Transducer connector on the TI box.
Secure the cable along its length so that it will not become damage
during testing. (For example tape it to the anti-rotate tube to prevent it
from getting caught in the tire tread.) Leave enough slack in the cable
to allow for the full range of wheel travel (jounce and steer).
Example Rear Anti-rotate Bracket Assembly (view from top)
Slip Ring/Encoder
Transducer
Transducer
Output Cable
Anti-rotate
Assembly
ATV Foot Peg
Anti-rotate bracket to be attached
to the foot peg support bracket
which will allow the slip ring anti-rotate
to move with the tire as
the ATV is moving or testing
S10-14
M4 Fasteners (2)