MTS SWIFT 10 ATV Sensor User Manual
Page 89
Road Simulator
SWIFT 10 ATV Sensors
Installing the Transducer
89
4. Position the vehicle in the test fixture.
The vehicle should be raised in a level manner, such that the orientation of
the anti-rotate bar is the same in the lifted position as it was in the grounded
position
Refer also to the instructions in your road simulator operation manual.
Adjust the fixture, as necessary, to allow the inner hub adapter to extend
through the spindle housing.
5. Use the twenty M8 fasteners to attach the transducer and washer plate to the
adapter plate. Ensure the electrical connectors on the transducer face
outward. Hand tighten the bolts.
A. Lubricate the threads and under the head of each fastener with
Molykote g-n paste.
B. Following the outer bolt pattern sequence shown in the next figure,
torque the twenty M8 bolts (1 through 20) to the value for the first
increment shown in the table on
C. Repeat Step 5B for the final increment.
6. Mount the slip ring bracket, with the slip ring installed, and the transducer
and adapter plate assembly to the inner hub adapter.
Note
For spinning mode application, before installing the slip ring bracket
locate the index mark on the slip-ring rotor and using a marker, transfer
this mark to the slip ring bracket. After installing the slip ring bracket,
transfer this mark to the adapter plate.
Spindle Housing
Inner Hub
Adapter
Vehicle
Spindle Hub
Adapter Plate
Transducer
M10 Fasteners
(16)
Washer Plate
M8 Fasteners
(20)
S10-34