MTS SWIFT 10 ATV Sensor User Manual
Page 91
Road Simulator
SWIFT 10 ATV Sensors
Installing the Transducer
91
7. Repeat steps 1 through 6 for each corner.
8. Attach a transducer output cable to the slip ring encoder connector and the
J3 Transducer connector on each TI box.
Secure the cables to the anti-rotate assembly so that it will not become
damaged during testing.
Be sure to leave enough slack for the full range of movement of the
simulation fixture.
9. Connect the power source to the J1 Power connector on the TI.
10. Connect the data cable from the J2 Output connector on the TI to the data
recorder or your test control system.
11. Before continuing with this procedure, proceed to
as required.
12. After completing Step 11,
A. For spinning mode only: Rotate the adapter plate to align the index
mark (see the first note in Step 6) as close as practical with the slip ring
connector while allowing the fasteners to be installed.
For fixed mode only: Rotate the adapter plate only enough to align the
mounting holes.
B. Attach the adapter plate to the spindle housing using the sixteen M10
fasteners.
Lubricate the threads and under the head of each fastener with
Molykote g-n paste.
C. Using a cross pattern, torque the sixteen M10 bolts to the value for the
first increment shown in the previous table.
D. Repeat Step 12C for the final increment.
E.
For fixed mode only: Measure the angle, caused by rotating the adapter
plate to attach the fasteners, and update the AngleFixed value in the
calibration file as described in to