MTS TestLine User Manual
Page 75
Advertising
Set the displacement limits to +40 mm and -40 mm so that you can achieve full extension and retraction.
2. Use manual command to find the actuator travel end points.
a) Using Manual Command, fully extend the actuator.
Extend the actuator fully, and then measure the length of the actuator so that you can later determine
where to set your limit detectors.
Note: If a displacement limit trips, see
If Necessary, Recover from a Tripped Displacement
(p. 113).
b) Using Manual Command, fully retract the actuator.
MTS TestLine Test System Operation | 75
Running the Example HCF Test
Advertising