Orbit Baby Generation-one Toddler Car Seat - Manual (Page 20)

Rear
-Facing Installation
38
38
Rear
-Facing Installation
39
39
Securing the Toddler Car Seat to the Base
requires fi rst lowering the Toddler Car Seat
to snap into the SmartHub
TM , then rotating
the Toddler Car Seat to lock into the Rear-
Facing Position.
1. Make sure the top of the Base and
SmartHub are clear of objects before
docking the Toddler Car Seat.
2. Grasp the Toddler Car Seat fi rmly (Photo
B). Dock the bottom of the Toddler Car
Seat into the circular SmartHub of the
Base until you hear and feel a CLICK
(Photo C).
3. Rotate the Toddler Car Seat until you
hear and feel another CLICK as it locks
into the Rear-Facing position (Photo D).
The Toddler Car Seat will only lock when
For increased comfort and ease of
use, the Toddler Car Seat can be
docked from almost any angle onto
the Base.
rotated into the Rear-Facing position.
Note that it will only lock when the
Release Levers are not pulled.
4. When locked into the Rear-Facing
position, make sure the Toddler Car
Seat does not touch the back of the
seat in front of it (Photo E).
5. CHECK the locked position by looking
at the Rotation Indicators on the Base
(Photo F). If they are fully red, then re-
dock the carseat.
NOTE: A small amount of rotational
movement is normal, but the carseat
should not pull off of the Base.
If the Rotation Indicators are fully red
with every docking attempt, check
to make sure your Orbit Base is
upgraded for Toddler Car Seat use.
See page 16 for details.
Docking the Toddler Car
Seat on the Orbit Base
B
C
D
E
F