Orbit Baby Generation-one Toddler Car Seat - Manual (Page 32)

Forwar
d-Facing Installation
62
62
Forwar
d-Facing Installation
63
63
The Braces are two supports (left and right)
that ensure a stable and secure installation
of the Toddler Car Seat when installed in
the car Foward-Facing (without the Orbit
Base). They come in a small bag, the
Brace Bag (Photo A), inside the box with
your Toddler Car Seat.
If you have misplaced the Braces,
visit www.orbitbaby.com/support
or call 1-877-ORB-BABY
(1-877-672-2229) for replacements.
Remove the Braces from the Brace Bag
and pull the Braces apart so they are ready
to be installed.
On each side of the Toddler Car Seat,
you will see two Brace Plugs - small grey,
fi gure-8 shapes. Each Plug has an opening
that will accept one of the metal rods
extending from the Brace (Photo B).
1. Ensure that the Locking Knob on
each Brace is turned to UNLOCKED.
(Photo C).
Attaching the Braces to
the Seat, Forward-Facing
3. Position each Brace on the appropriate
side of the carseat: Make sure that the
RED strip on the Brace matches the
RED Forward-Facing strip on the label
near the back of the carseat, and that
the FRONT OF VEHICLE arrow will face
the front of your vehicle (Photo D).
4. Slide both Brace Rods evenly into
the Brace Plug openings in the shell
until the Brace is fully docked and you
cannot see the Brace Rods anymore
(Photo E).
5. Turn the Locking Knob to lock the Brace
in place by fi rst pushing it in, then
turning (Photo F). Tug on the Brace to
ensure that it is locked in position.
A small amount of movement is
normal, but the Brace should not
pull off.
6. Install the remaining Brace on the other
side of the Toddler Car Seat by following
steps 1-5.
A
B
C
D
E
F
Braces
Brace Bag