Orbit Baby Generation-one Toddler Car Seat - Manual (Page 48)

94
94
T
raveling with Y
our T
oddler Car Seat
95
T
raveling with Y
our T
oddler Car Seat
95
Your Toddler Car Seat comes with a UV
Sunshade. This Sunshade can be used in
the car to keep sun off your child and can
also be used when the Toddler Car Seat is
docked on the Orbit Stroller.
The Sunshade can easily be stored when
not in use in the Rear Access Panel, only
in the pocket provided.
To install the Sunshade on the Toddler
Car Seat:
1. Insert the green plastic Fittings on the
Sunshade into the slots on the shell
(Photo F). Be sure to keep the silver
fabric underneath, towards the child’s
seating area. The Fittings should softly
click when fully inserted.
Using Your UV Sunshade
2. Stretch the backside of the Sunshade
over the rim of the seat (Photo G).
3. Snap sides of the Sunshade onto the
Upholstery snaps (Photo H).
To remove the Toddler Car Seat
Sunshade:
Unsnap the sides of the Sunshade. Pull
the backside of the Sunshade out from
under the rim of the seat. Push each
Sunshade Fitting out of its slots from
the back of the shell as you squeeze
the buttons on the Fittings (Photo I). Be
careful as you remove the Sunshade
because it will spring outwards.
To stow the Toddler Car Seat Sunshade:
1. Open the Rear Access Panel.
2. Gently fold the Sunshade in half (Photo
J) and insert it into the pocket, rounded
side fi rst (Photo K). The Fittings should
stick out of the top of the pocket.
3. The Sunshade must be fully inside in
order to close the Rear Access Panel.
! WARNING !
Do not lift the Toddler Car Seat by
the Sunshade. The Sunshade could
detach and the seat could fall,
injuring your child.
F
G
H
I
J
K
Sunshade
Fitting
snap