Orbit Baby Generation-one Toddler Car Seat - Manual (Page 35)

Forwar
d-Facing Installation
68
68
Forwar
d-Facing Installation
69
69
Forwar
d-Facing Installation
68
68
1. Install Orbit Toddler Car Seat Braces,
Forward-Facing: See pages 62-63.
2. If you will be attaching the Tether later
(refer to page 72), open the Rear Access
Panel and unclip the Tether Hook from
the secured ring (Photo A). Pull the
Tether Strap out fully and secure the Rear
Access Panel with the back clip.
3. Position the Toddler Car Seat on the
vehicle seat. The seat, as well as the
FRONT OF VEHICLE arrow on the Braces,
should face front. If using the Top Tether,
drape it over the rear of the vehicle seat.
4. Lift the Upper Upholstery Panel marked
by a Red Dot (Photo B). You can keep it
out of the way by wedging it into the sides
of the Upholstery.
5. Open both arms of both Red Belt Lock-
Off Clamps (Photo C). Pull the seat belt
through the Forward-Facing Belt Path in
the seat shell (Photo D).
6. Position only the lap portion of the seat
Installation with Braces &
Shoulder-Lap Seat Belts
(without Orbit Base)
belt in the fi rst clamp you pass (Photo E),
then position both the shoulder and lap
belts through second clamp (Photo F).
Two magnets on the shell help hold the
vehicle seat belt’s tongue in place for your
convenience. Buckle the belt.
7. If your car is model year 2000 or newer, it
probably has vehicle seat belts with Auto
Retraction Mode (consult your vehicle
manual). If this is the case, pull the
shoulder belt all the way out to its fullest
extent to engage the vehicle belt in Auto
Retraction Mode. You should hear a low
clicking as you feed it back into the car.
8. Push down on the seat and pull sideways
on the shoulder portion of the belt to
tighten the seat belt.
9. When the belt is tight, push down both
arms of both Red Belt Lock-Off Clamps
fi rmly until they lock (listen for a CLICK).
10. CHECK that the installation is secure by
tugging the Toddler Car Seat near the belt
path. It should not move more than 1 inch
in any direction. If it the Toddler Car Seat
is loose, re-install from Step 3.
11. Close the Upper Upholstery Panel and
install the Top Tether: See pages 72-73.
B
C
A D
E
F
First Clamp
Second Clamp