Orbit Baby Generation-one Toddler Car Seat - Manual (Page 24)

Rear
-Facing Installation
46
46
Rear
-Facing Installation
47
47
6. Position the carset Rear-Facing on the
vehicle seat. The child seat should face
the rear of the vehicle. The FRONT OF
VEHICLE arrow on the Braces should
point to the front of your vehicle.
7. Open the Upholstery Lower Panel
marked by the Blue Dot.
8. Fully open both arms of the blue Belt
Lock-Off Clamp that will be closest
to the center of the vehicle in the fi nal
installation (Photo A).
NOTE: If installing the seat in the
center position, open either Clamp.
Only one Clamp is needed for a secure
installation.
9. Feed the LATCH Belt through the Rear
Facing Belt Path in the shell and the
open Blue Lock-Off Clamp. Ensure that
the pictogram on the LATCH connectors
face the outside of the vehicle (Photo B).
Center the yellow stitch line of the LATCH
Belt on the carseat shell (Photo C).
10. Secure the open Blue Lock-Off Clamp
fi rmly upon the LATCH belt by fl ipping
the two Clamp arms down over the belt
and locking them in place. (Listen for a
CLICK) (Photo D).
11. Buckle both LATCH Connectors
by pushing onto the vehicle lower
anchorage on each sides of the car seat.
Pull to be sure they are locked to the
vehicle’s anchorage point (Photo E).
12. To tighten LATCH belt around carseat,
push down on the seat and pull the
loops at the ends of the lower anchor
belt (Photo F).
13. CHECK that the installation stays
securely tightened by tugging and
pulling the Toddler Car Seat in various
directions. The Toddler Car Seat should
not move by more than 1 inch in any
direction. If it is loose, push down
on the seat and pull the LATCH belts
tighter. If the seat is still loose, remove
and re-install it beginning at Step 7.
Installation with Braces & LATCH System
(without Orbit Base) cont’d
A
B
C
D
E
F