Orbit Baby Generation-one Toddler Car Seat - Manual (Page 21)

Rear
-Facing Installation
40
40
Rear
-Facing Installation
41
41
6. Do a fi nal CHECK each time you re-
dock: pull the Toddler Car Seat in several
directions (Photo H) to be certain it is
locked. It should not rotate out of the
Rear-Facing position. If it does, remove
the carseat and contact Orbit Baby.
To rotate and remove the Toddler Car
Seat from the Base:
1. Squeeze one or both Release Levers
upward (Photo I). As you squeeze the
Release Levers, the Hub Locks retract
and the Toddler Car Seat can be rotated.
2. Squeeze the Release Levers fully to lift
the Toddler Car Seat out of the Base
while grasping the seat securely with
both hands (Photo J).
! WARNING !
Death or Serious Injury Can Occur
FALL HAZARD: Grasp the Toddler
Car Seat fi rmly by sides and seat front
when lifting. PINCH HAZARD: Clear
your child’s fi ngers and hands from
the Side Handle area.
The Braces are two supports (left and right)
that ensure a stable and secure installation
of the Toddler Car Seat when installed in
the car without the Orbit Base. They come
in a small bag, the Brace Bag, inside the
box with your carseat (Photo K).
Before starting the installation, remove
the Braces from the Brace Bag and pull
the Braces apart so they are ready to be
installed.
On each side of the Toddler Car Seat,
you will see two Brace Plugs - small grey,
fi gure-8 shapes. Each Plug has an opening
that will accept one of the metal rods
extending from the Brace (Photo L).
Attaching the Braces to
the Seat, Rear-Facing Only
! WARNING !
Never use the Toddler Car Seat
without either the Braces or the
Orbit Base. If you have misplaced
the Braces, visit:
www.orbitbaby.com/support or call
1-877-ORB-BABY (1-877-672-2229).
H
I
J
K
L
Braces
Brace Bag