Orbit Baby Generation-one Toddler Car Seat - Manual (Page 26)

Rear
-Facing Installation
51
51
Rear
-Facing Installation
50
50
Rear
-Facing Installation
51
51
6. Push down, and pull sideways on the
shoulder portion of the belt to tighten
seat belt around the child restraint.
7. When tight, push down both arms of
the open Blue Clamp fi rmly until it locks
(Listen for a CLICK) (Photo M).
8. If your car is model year 2000 or newer,
it probably has vehicle seat belts with
Auto Retraction Mode (consult your
vehicle manual). If this is the case,
pull the shoulder belt out to its fullest
extent to engage the vehicle belt in Auto
Retraction Mode. You should hear a low
clicking as you feed it back into the car.
9. CHECK that the installation is secure by
tugging and pulling the Toddler Car Seat
near the belt path in various directions
– the Toddler Car Seat should not move
more than 1 inch in any direction If it is
loose, remove and re-install it beginning
at Step 3.
10. Check that the Toddler Car Seat is
level by looking at the Level Indicator
on the Brace (Photo N). If the seat is
not level, remove the seat and reinstall
by repeating Steps 3 to 8. If the Toddler
Car Seat cannot be secured tightly and
leveled, try any of the following:
a) Try installing the Toddler Car Seat in a
different seating position.
b) Remove the seat. Position a rolled towel
underneath it (Photo O) and repeat
Steps 2 to 8.
c) Seek assistance from one of the
resources in the “Need Help Securing
Your Toddler Car Seat and Base?” (Page
27).
NOTE: The Toddler Car Seat must be
properly level to prevent ejection. Do
not use until properly installed.
11. Close the Upholstery Lower Panel.
Installation with Braces & Shoulder-Lap
Seat Belts (without Orbit Base) cont’d
M
N
O