Orbit Baby Generation-one Toddler Car Seat - Manual (Page 34)

Forwar
d-Facing Installation
66
66
Forwar
d-Facing Installation
67
67
5. When closing the Rear Access Panel,
look for the notches near the bottom of
the Panel. Position the LATCH Leash
in either notch so that the panel closes;
fully pull the Tether Strap out of the
pocket (Photo M). Secure the Rear
Access Panel with the clip.
6. Position the carseat Forward-Facing on
the vehicle seat. The carseat faces the
front of the vehicle and the FRONT OF
VEHICLE arrow on the Braces points
to the front of your vehicle. If using the
Top Tether, drape it over the rear of the
vehicle seat; it will be secured later.
7. Unbuckle the Restraint Harness on the
seat. Lift the Upper Upholstery Panel
marked by the Red Dot (Photo N). It will
stay out of the way by wedging it into
the sides of the Upholstery (Photo O).
8. Open both arms of the red Belt Lock-
Off Clamp closest to the center of the
vehicle (Photo P).
9. Feed the LATCH belt through the
Installation with Braces & LATCH System
(without Orbit Base) cont’d Forward-Facing Belt Path in the shell
and the Clamp. Ensure that the LATCH
connectors face the outside of the
vehicle (Photo Q). Center the yellow
stitching across the carseat (Photo R).
10. Secure the open Red Belt Lock-Off
Clamp fi rmly upon the LATCH belt by
fl ipping the two arms down over the belt
and locking them in place.
11. Buckle both LATCH Connectors into
the vehicle anchors on each side of the
carseat. Pull to be sure they are locked
to the vehicle’s anchorage points.
12. To tighten LATCH belt around carseat,
push down on the seat and pull the
loops at the ends of the lower anchor
belt.
13. CHECK that the installation is secure
by tugging and pulling the carseat near
the belt path. The Toddler Car Seat
should not move more than 1 inch in
any direction If it is loose, tighten the
LATCH belts or reinstall from Step 6.
14. Close the Upper Upholstery Panel and
install the Top Tether: See pages 72-73.
M
N
O
P
Q
R