Orbit Baby Generation-one Toddler Car Seat - Manual (Page 40)

78
78
Securing Y
our Child
Securing Y
our Child
79
79
7. Pull up on the Crotch Buckle and
the Shoulder Straps to CHECK they
are secure (Photo F). DO NOT use
the Toddler Car Seat if the Restraint
Harness does not feel secure, and
contact Orbit Baby.
8. To tighten the lap section of the
Restraint Harness, gently pull up on the
Shoulder Straps (Photo G).
9. To tighten the Shoulder Straps, slowly
pull the Adjuster Strap that hangs from
the front of the carseat, adjusting the
Restraint Harness snugly against the
child (Photo H).
11. CHECK again that the Restraint
Harness straps are not twisted.
12. CHECK that the Restraint Harness is
snug on shoulders and thighs (Photo
I). A snug strap should not allow
any slack. The straps should lie in
relatively straight lines without sagging.
They should not press on the child’s
fl esh or push the child’s body into an
unnatural position.
Buckling the Restraint Harness cont’d
13. Proceed to page 80, “Adjust the
Restraint Harness to Fit Your Child,”
to determine whether your child fi ts in
the Restraint Harness properly and to
adjust if necessary.
To remove your child from the Toddler
Car Seat:
1. Loosen the Restraint Harness by
pressing and holding the Adjuster
Strap Lock, while pulling up on the
shoulder straps (Photo J).
2. Open the Chest Clip by squeezing the
Tabs and separating the two halves
(Photo K).
3. Unbuckle the Crotch Buckle by
pressing the Red button (Photo L).
3. For convenience, secure the Restraint
Harness to the sides with the side hook-
and-loop fastener dots and remove your
child.
G
H
I
J
K
L
Adjuster
Strap
Lock