BT In Touch 2000 - Manual (Page 72)

72
T
esting
in
an
emergency
situation
Testing the range of your
BT In Touch Pendant
Now test the range of your BT In Touch
Pendant in your home environment - you may
want to use 2 people to do this.
Press the Pendant button in different locations
around the house and garden to make sure
that your BT In Touch 2000 User Phone is able
to pick up the emergency signal.
Please note
If your BT In Touch Pendant does not work over
the full 50 metre range, it does not mean it is
faulty. The nature of radio transmission technology
is such that environmental conditions can effect the
performance of the BT In Touch Pendant.
It is your responsibility to establish the range over
which your BT In Touch Pendant works
RELIABLY. It would be advisable for the User to
spend as little time as possible in places where
reception is poor.
Establishing the reliable range of your pendant
in your own home conditions will give you
confidence.
Helpful timer whilst testing your
Pendant/Emergency button
To set the delay time
There are 2 settings which set the
delay time between pushing the
Emergency button (phone/pendant)
and starting the emergency sequence.
Code 10 1 second
Code 11 9 seconds
You can set the emergency timer to
9 seconds to help you with your
BT In Touch Pendant test as follows:
Lift the label surrounding the
Quickdial memory buttons to reveal
the Announce and Setup buttons.
Press the Setup button.
The display will show:
Enter 11 from the keypad (for a
9-second delay). The display shows:
9 SECOND DELAY
SET UP
Setup
Announce
Setup
SET UP