Gen3 pro sefi system optional features – Precision Turbo and Engine BigStuff3 GEN3 PRO SEFI System Hardware & BigComm Software User Manual

Page 5

Advertising
background image

BigStuff3 Pro SEFI System

Version 2.1 – February 2011

5

 Aesthetically pleasing, nylon braided wire harnesses with integrated ECU and Injector/WBO2

fuse protection.

 OEM style Packard & TYCO waterproof connectors & terminals

GEN3 PRO SEFI System Optional Features

New four (4) Stage, Dry Nitrous, Oxide System available in February 2011! For

more information, see the manual on our website under Manuals.

Integrated CO2 Boost controller! No longer any need for a separate,

standalone

system.

EJET – Electronic carburetor! Call BigStuff3 for more details.

 Wide-band methanol control down to 2.9:1 A/F ratio
 Engine Torque Management systems (ETM and SR2 or ETM/SR2) using cylinder cut-off, spark

or a combination of both!

 CAN interface to:

 Various RacePak

tm

dashes. Send GEN3 engine operating information directly to a

RacePak dash.

 Racepak

tm

V300 or 500 data acquisition systems. Send GEN3 engine and powertrain data

to a Racepak

tm

data acquisition system and avoid having to buy redundant sensors.

 RacePak

tm

EGT monitoring and recording. The GEN3 system can also data log RacePak

EGT Data without the need for another external data acquisition system.

 E10 – E85 ethanol “flex fuel” systems for COP and distributor based GEN3 systems. Uses a GM

style “flex fuel” sensor.

 Sequential fuel control for up to 24 injectors low (or high) impedance injectors, in a staged

configuration.

 Barometric Pressure Compensation
 Transmission control for GM 4L60E/80E transmissions.
 Data Logging Internal (DAI) - 128k of on board RAM for internal data logging – 52 user selectable

channels (twenty two (22) 16 bit channels & thirty (30) 8 bit channels), 10-bit resolution, with a 50Hz

acquisition rate.

 Data Logging External (DAE & DAE-2) - Additional data logging capabilities of the following

engine/vehicle parameters

- Fuel pressure (150 psi)

- Oil Pressure (150 psi)

- Turbo back Pressure (150 psi)

- Trans Line Press (500 psi) - Drive shaft RPM

- Turboshaft RPM

Advertising