RKI Instruments Eagle 2 - Manual (Page 84)

80 • Detail Settings Button
2 by using the POWER ENTER RESET button on the Eagle
2 or by clicking the Power Off button and confirming that you
want to turn off the Eagle 2 when the Power Off Window
appears. Then click the Exit button to exit the software.
Detail Settings Button
The Detail Settings button allows the user to create or change a
User ID list or Station ID list and upload it to an instrument, view
the pre-defined relative response gases for the catalytic
combustible channel and edit or add user-defined gases, and
view the pre-defined relative response gases for the PID sensor
and to view or define the 1 user-defined relative response gas.
A Select Distributed File button is located in the bottom right
corner of the Detail Settings window. This control button only
becomes active after data has been downloaded to the Data
Logger Management Program. The function controlled by this
button is not needed for normal field use of the program. This
function is for use by field service personnel with a factory
program at their disposal to generate a distributed file.
The detail settings button is located along the left part of the Set
window under the font and graph color buttons. To update any of
the parameters found in the Detail Settings window in an
instrument, you must first connect the instrument to the
program.
1. Launch the Eagle 2 Data Logger Management Program.
2. If the Automatic Download selection box is selected,
deselect it.
3. Connect an instrument to the program. See “Downloading
Data from the Eagle 2” on page 15, instruction 2 through
instruction 3, to connect an instrument to the program.
4. Once the connection is made, the Complete Download,
Instrument Information, and Power Off download
commands will be selectable. Click the Instrument
Information download command to retrieve the instrument
information from the instrument. If you wish to download data
before making changes, click Complete Download instead