Summit REX242W - Manual (Page 10)

10
1. BAKE Pad
Touch this pad to select the bake function.
BAKE Light
Flashes while in edit mode - you can change
the oven temperature this point.
2. BROIL HI/LO Pad
Touch this pad to select the broil function.
BROIL Light
Flashes while in edit mode - you can switch
from HI to LO BROIL at this point.
3. Display
Shows the operations you have selected, the
time of day and the cooking status.
4. COOK TIME Pad
Touch this pad and then touch the + or –
pad to set the amount of time you want your
food to cook. The oven will shut off when the
cooking time has run out.
5. START TIME Pad
Use along with the COOK TIME or SELF CLEAN
pad to set the oven to start and stop auto-
matically at a time you set.
6. OVEN LIGHT ON/OFF Pad
Touch this pad to turn the oven light on or off.
7. TIMER/CLOCK Pad
Touch this pad to select the timer feature.
Then press + and – pads to adjust time.
To set the clock, touch this pad and hold 3
seconds and then touch the + and – pads.
The time of day will flash in the display when
the oven is first turned on.
Using the oven controls. (on some models)
Throughout this manual, features and appearance may vary from your model.
Oven Control, Clock and Timer Features and Settings
8. START Pad
Must be touched to start any cooking func-
tion.
9. – Pad
Short taps to this pad will decrease the time
or temperature by small amounts. Touch and
hold the pad to decrease the time or tem-
perature by larger amounts.
10. + Pad
Short taps to this pad will increase the time or
temperature by small amounts. Touch and
hold the pad to increase the time or tem-
perature by larger amounts.
11. CLEAR/OFF Pad
Touch this pad to cancel ALL oven opera-
tions except the clock and timer.
12. SELF CLEAN Pad
Touch this pad to select the self-cleaning
function. See the Using the self-cleaning oven
section.
CLEAN Light
Flashes while in edit mode-you can change
the length of time for the self-clean cycle at
this point. Glows when the oven is in the self-
clean cycle. After the self-clean cycle, the
light will turn off. Unlatch the door.
12 11 10
1 2 3 4 5
9 8 7 6
If "F-and a number, or letter" flash in the display
and the oven control signals, this indicates a
function error code.
Touch the CLEAR/OFF pad. Allow the oven to
cool for one hour. Put the oven back into op-
eration.
If function error code repeats, disconnect
power to the oven and call for service.
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips
Consumer Support
Installation Instructions