Summit REX242W - Manual (Page 38)

38
Leg
leveler
Lower
range
Raise
range
Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION 9 REMOVE STORAGE DRAWER 10
A
LEVEL THE RANGE 11
A
B
WARNING
Tip-Over Hazard
A child or adult can tip the range and be killed. Verify
the anti-tip bracket has been properly installed and
engaged.
Ensure the anti-tip bracket is re-engaged when the
range is moved.
Do not operate the range without the anti-tip bracket in
place and engaged.
Failure to follow these instructions can result in death or
serious burns to children or adults.
To reduce the risk of tipping the range, the range must
be secured by a properly installed anti-tip bracket. See
installation instructions shipped with the bracket for
complete details before attempting to install.
To check if the bracket is installed and engaged prop-
erly, look underneath the range to see that the anti-tip
arm attached to the side panel is engaged in the
bracket. On some models, the storage drawer or kick
panel can be removed for easier inspection. If visual in-
spection is not possible, slide the range forward, con-
firm the anti-tip bracket is securely attached to the floor
or wall, and slide the range back so the anti-tip arm
slides just under the anti-tip bracket. If the range is
pulled from the wall for any reason, always repeat this
procedure to verify the range is properly secured by
the anti-tip bracket.
Pull the drawer out all the way.
Lift the front of the drawer until the stops clear the
guide.
Remove the drawer.
Check for levelness by placing a spirit level or a
cup, partially filled with water, on one of the oven
racks. If using a spirit level, take two readings - with
the level placed diagonally first in one direction
and then the other.
Lift the front of the drawer until the stops clear the
guide.
Remove the drawer.
B
C
Install the oven racks in the oven and position the
range where it is to be installed.
The front leveling legs can be adjusted from the
bottom and the rear legs can be adjusted from the
top or the bottom.
C
D Use an open-end or adjustable wrench to adjust
the leveling legs until the range is level.