Summit REX242W - Manual (Page 43)

43
Unable to get the dis-
play to show "SF"
Oven control pads were not
pressed properly.
• The BAKE and BROIL pads must be pressed at the
same time and held for 3 seconds.
Display flashes Power failure. • Reset the clock.
Power outage Power outage or surge. • Some models will automatically resume their setting
once the power is restored. On models with a clock,
you must reset the clock. If the oven was in use, you
must reset it by pressing the OFF pad, setting the clock
and resetting any cooking function.
"F-and number or let-
ter" flash in the display
You have a function error code. • Press the OFF pad. Put the oven back into operation.
If the function code repeats: • Disconnect all power to the range for at least 30 sec-
onds and then reconnect power. If the function error
code repeats, call for service.
• On self-cleaning models, if a function error code ap-
pears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch is
moved to the right as far as it will go. Press the OFF
pad. Allow the oven to cool for one hour. Put the oven
back into operation.
Oven makes clicking
noise
This is the sound of the heating
element turning off and on dur-
ing cooking functions.
• This is normal.
Oven door is crooked The door is out of position. • Because the oven door is removable, it sometimes
gets out of position during installation. To straighten the
door, push down on the high corner.
Display goes blank A fuse in your home may be
blown or the circuit breaker
tripped.
• Replace fuse or reset circuit breaker.
The clock is turned off from show-
ing in the display.
• See the Using the clock, timer and convenience outlet
section.
Oven controls improperly set. • See the Using the clock, timer and convenience outlet
section.
Clock and timer do
not work
Plug on range is not completely
inserted in the electrical outlet.
• Make sure electrical plug is plugged into a live, prop-
erly grounded outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
• Replace fuse or reset circuit breaker.
Oven temperature too
hot or too cold
Oven thermostat needs adjust-
ment.
• See the Adjust the oven thermostat-Easy to do your-
self! Section.
Before you call for service...
Problem Possible Causes What To Do
Safety Instructions
Operating
Instructions
Care and Cleaning
Troubleshooting Tips
Consumer Support
Installation Instructions