Summit REX242W - Manual (Page 35)

35
Strain relief
Power cord Bracket
Terminal
block
Terminal block
(appearance
may vary)
Knockout ring
in bracket
Knockout ring
removed
2 screws
to remove
wire cover
Back of Range Wire cover
Installation Instructions
ELECTRICAL CONNECTIONS (CONT.)
POWER CORD AND STRAIN RELIEF
INSTALLATION
3
A
B
C
D
For conduit installations only, purchase a squeeze
connector matching the diameter of your conduit
and assemble it in the hole. Insert the conduit through
the squeeze connector and tighten. Allow enough
slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze
connector. The squeeze connector should be in-
stalled before reinstalling the rear range wiring cover.
Remove the wire cover (on the back of the range) by
removing two (2) screws using a Phillips screw driver.
Do not discard these screws.
Remove the knockout ring (1 3/8") located on
bracket directly below the terminal block. To remove
the knockout, use a pair of pliers to bend the knock-
out ring away from the bracket and twist until ring is
removed.
For power cord installations only (see the next step if
using conduit), assemble the strain relief in the hole.
Insert the power cord through the strain relief and
tighten. Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are present at
the end of the winged strain relief, they can be re-
moved for better fit.
NOTE: Do not install the power cord without a strain re-
lief. The strain relief bracket should be installed before
reinstalling the rear range wiring cover.
Skip to Step 4 or 5.
Skip to Step 6 or 7.
Squeeze
connector
Conduit
Bracket
Terminal
block