Barco R9001330 - Manual (Page 113)

Optional Equipment
14-2 5975288 BARCOGRAPHICS 8200 110497
Optional Equipment
14-2 5975288 BARCOGRAPHICS 8200 110497
IR Receiver 800
This infra red receiver unit makes it possible to control
the BARCOGRAPHICS 8200 from another room.
There is a communication line with cable between the
IR receiver and the projector or the RCVDS. The control
information from the RCU can now be sent to this IR
receiver.
The IR receiver 800 displays the selected source on a
7-segment display.
Order number : R9827515
S c r e e n
C o mm u n ic atio n ca b le
B A R C OG R A P H IC S 8 1 0 0
IR R e m o te R e c eiv e r 8 0 0
P r o j e c ti o n r o o m C o n t r o l r o o m
shield
conductor
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a wired
connection. (How to use the hardwired RCU, see chapter Controlling)
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R3131991).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side
in the connector on the rear of the projector labelled ‘remote’.
IR Receiver 800
This infra red receiver unit makes it possible to control
the BARCOGRAPHICS 8200 from another room.
There is a communication line with cable between the
IR receiver and the projector or the RCVDS. The control
information from the RCU can now be sent to this IR
receiver.
The IR receiver 800 displays the selected source on a
7-segment display.
Order number : R9827515
S c r e e n
C o mm u n ic atio n ca b le
B A R C OG R A P H IC S 8 1 0 0
IR R e m o te R e c eiv e r 8 0 0
P r o j e c ti o n r o o m C o n t r o l r o o m
shield
conductor
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a wired
connection. (How to use the hardwired RCU, see chapter Controlling)
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R3131991).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side
in the connector on the rear of the projector labelled ‘remote’.