Barco R9001330 - Manual (Page 119)

Optional Equipment
14-8 5975288 BARCOGRAPHICS 8200 110497
Optional Equipment
14-8 5975288 BARCOGRAPHICS 8200 110497
Mechanical Shutter
BARCO's mechanical shutter can be used there where the display
has to be totally black when the projector is set in pauze. This can be
very useful when the projector is used together with a slide-projector.
Features:
- Is installed inside the projector.
- The shutter is controlled through the 'pause' button on the RCU.
- The shutter is powered through the power supply of the projector.
- The fading time is adjustable through RS232 communication.
- Reaction time less than 0.5 seconds.
Order number : R9829270
Adjustable lensholder
With BARCO's special adjustable lensholder, it is possible to shift the
displayed picture of the BARCOGRAPHICS 8200 projector up or
down on the screen, without moving the projector from its normal
position, and without any geometric picture distortion. This system
is particularly useful for use in dual or triple projector configurations,
or for applications where the projector can not be installed in its
standard position.
Features :
- Vertical shift of the lens possible between 20 mm (0.79") up to 6 mm
(0.24") down without removing the projector cover.
- Shift of the displayed picture on the screen up till 2 meters (6.5 ft)
over its standard position.
- Makes it possible to project a geometric non-distored picture from
a non-standard projection position.
- The shift of the lensholder is not determined by the lens used, but
depends on the screen width.
- Can be used with all available lenses.
- Can be used in dual or triple configuration in combination with
BARCO's projection frame or multifunctional flight case.
Mechanical Shutter
BARCO's mechanical shutter can be used there where the display
has to be totally black when the projector is set in pauze. This can be
very useful when the projector is used together with a slide-projector.
Features:
- Is installed inside the projector.
- The shutter is controlled through the 'pause' button on the RCU.
- The shutter is powered through the power supply of the projector.
- The fading time is adjustable through RS232 communication.
- Reaction time less than 0.5 seconds.
Order number : R9829270
Adjustable lensholder
With BARCO's special adjustable lensholder, it is possible to shift the
displayed picture of the BARCOGRAPHICS 8200 projector up or
down on the screen, without moving the projector from its normal
position, and without any geometric picture distortion. This system
is particularly useful for use in dual or triple projector configurations,
or for applications where the projector can not be installed in its
standard position.
Features :
- Vertical shift of the lens possible between 20 mm (0.79") up to 6 mm
(0.24") down without removing the projector cover.
- Shift of the displayed picture on the screen up till 2 meters (6.5 ft)
over its standard position.
- Makes it possible to project a geometric non-distored picture from
a non-standard projection position.
- The shift of the lensholder is not determined by the lens used, but
depends on the screen width.
- Can be used with all available lenses.
- Can be used in dual or triple configuration in combination with
BARCO's projection frame or multifunctional flight case.