Barco R9001330 - Manual (Page 32)

Installation Set Up
Installation Set Up
5975288 BARCOGRAPHICS 8200 110497 4-3
4-3 5975288 BARCOGRAPHICS 8200 110497
To change the Configuration, enter the adjustment mode by pushing ADJUST or
ENTER .
Highlight Installation by pushing the control disk up or down and press ENTER to
select. The installation menu will be displayed.
ENTER displays the Installation menu.
EXIT returns to operational mode.
Select with or
then <ENTER>
<EXIT> to return.
Highlight Configuration by pushing the control disk up or down and press ENTER to
select. The configuration menu will be displayed.
ENTER displays the Configuration menu.
EXIT returns to the path selection menu.
ADJUST retuns to operational mode.
The actual selected configuration will be highlighted.
Push the control disk up or down to select the corresponding configuration with
regard to the projector environment. Press
ENTER to confirm your selection.
ENTER to confirm the selection.
EXIT returns to the installation menu.
ADJUST retuns to operational mode.
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
CONFIGURATION
FRONT/TABLE
FRONT/CEILING
REAR/TABLE
REAR/CEILING
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
INSTALLATION
INPUT SLOTS
CONVERGENCE
CONFIGURATION
INTERNAL PATTERNS
To change the Configuration, enter the adjustment mode by pushing ADJUST or
ENTER .
Highlight Installation by pushing the control disk up or down and press ENTER to
select. The installation menu will be displayed.
ENTER displays the Installation menu.
EXIT returns to operational mode.
Select with or
then <ENTER>
<EXIT> to return.
Highlight Configuration by pushing the control disk up or down and press ENTER to
select. The configuration menu will be displayed.
ENTER displays the Configuration menu.
EXIT returns to the path selection menu.
ADJUST retuns to operational mode.
The actual selected configuration will be highlighted.
Push the control disk up or down to select the corresponding configuration with
regard to the projector environment. Press
ENTER to confirm your selection.
ENTER to confirm the selection.
EXIT returns to the installation menu.
ADJUST retuns to operational mode.
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
CONFIGURATION
FRONT/TABLE
FRONT/CEILING
REAR/TABLE
REAR/CEILING
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
INSTALLATION
INPUT SLOTS
CONVERGENCE
CONFIGURATION
INTERNAL PATTERNS