Barco R9001330 - Manual (Page 57)

Controlling
8-2
Controlling
8-2 5975288 BARCOGRAPHICS 8200 110497
5975288 BARCOGRAPHICS 8200 110497
The BARCOGRAPHICS 8200 can be controlled with
a. the RCU
b. the hardwired RCU (cable is not included)
c. the local keypad.
Controlling the projector with the RCU and the hardwired RCU is
equal.
How to use the RCU?
a) Point the front of the RCU to the reflective screen surface.
Ceil i ng
S c r e e n
I R s ens or
R C U
b) RCU used in a hardwired configuration.
1 0 0 - 2 30 V
9 - 4 A 60 - 5 0 H z R S 2 3 2 O U T 0 I
T hi s d e v ic e c o mp l ie s w i t h P ar t 1 5 o f t h e F C C r ul e s. O p e r a t io n
i s s ub j e ct to fo l l ow i ng t w o c o nd i ti o n s :
( 1) T h is de vi c e ma y n ot ca u se h a r m fu l i nt e r f e r e nc e
( 2) T h is d e vi ce mu st ac ce pt an y i nt er f er en c e r e c ei ve d
i nc lu d in g in t er f er en c e t ha t m ay c a us e u nd e si r ed o p er a ti on
IR -ACK NOW LEDG ED
IR -REC EIV ED
DIAGNOSTICS CO DE IR -R ECE IV ER
Plug one end of the remote cable in the connector on the bottom of
the RCU and the second side in the connector in the front panel of the
BARCOGRAPHICS 8200 labelled 'REMOTE'.
The BARCOGRAPHICS 8200 can be controlled with
a. the RCU
b. the hardwired RCU (cable is not included)
c. the local keypad.
Controlling the projector with the RCU and the hardwired RCU is
equal.
How to use the RCU?
a) Point the front of the RCU to the reflective screen surface.
Ceil i ng
S c r e e n
I R s ens or
R C U
b) RCU used in a hardwired configuration.
1 0 0 - 2 30 V
9 - 4 A
60 - 5 0 H z R S 2 3 2 O U T 0 I
T hi s d e v ic e c o mp l ie s w i t h P ar t 1 5 o f t h e F C C r ul e s. O p e r a t io n
i s s ub j e ct to fo l l ow i ng t w o c o nd i ti o n s :
( 1) T h is de vi c e ma y n ot ca u se h a r m fu l i nt e r f e r e nc e
( 2) T h is d e vi ce mu st ac ce pt an y i nt er f er en c e r e c ei ve d
i nc lu d in g in t er f er en c e t ha t m ay c a us e u nd e si r ed o p er a ti on
IR -ACK NOW LEDG ED
IR -REC EIV ED
DIAGNOSTICS CO DE IR -R ECE IV ER
Plug one end of the remote cable in the connector on the bottom of
the RCU and the second side in the connector in the front panel of the
BARCOGRAPHICS 8200 labelled 'REMOTE'.
Cable not included
Cable not included