Installation – Barco R9001330 User Manual
Page 93
Installation
12-7
Installation
5975288 BARCOGRAPHICS 8200 110497
12-7
5975288 BARCOGRAPHICS 8200 110497
If both lines are correctly converged, continue with screw 4.
Adjust screw 4 until line 4 is correctly converged. It is possible that line 2 and 3 have
to be reconverged. If so, repeat procedure for screw 2 and 3 (step b and c)
If line 2, 3 and 4 are converged, continue with line 1 (screw 1).
When line 1 is converged, check again the convergence of lines 2, 3 and 4. If necessary
repeat the above procedure for the corresponding lines.
Check if lines 5 and 6 are correctly converged. If so, press
EXIT
to return to the
Test
pattern
menu and continue with Blue on green.
If not yet correctly converged, check the distance between lines 5 and 6 of the red
pattern and the distance between lines 5 and 6 of the green lines.
Two possibilities :
1) distance between red lines is smaller than distance between green lines.
Turn screw 5 and 6 clockwise until distance between lines 5 and 6 is the same for the
red and green lines.
2) distance between red lines is greater than distance between green lines.
Turn screw 5 and 6 counter clockwise until distance between lines 5 and 6 is the same
for the red and green lines.
Due to this movement the lines 1, 2, 3 and 4 may be out of convergence. Repeat the
above mentioned steps for the respective lines.
If all lines are correctly converged, press
EXIT
to return to the
Test pattern
menu.
4
1
6
5
3
2
4
1
6
5
3
2
If both lines are correctly converged, continue with screw 4.
Adjust screw 4 until line 4 is correctly converged. It is possible that line 2 and 3 have
to be reconverged. If so, repeat procedure for screw 2 and 3 (step b and c)
If line 2, 3 and 4 are converged, continue with line 1 (screw 1).
When line 1 is converged, check again the convergence of lines 2, 3 and 4. If necessary
repeat the above procedure for the corresponding lines.
Check if lines 5 and 6 are correctly converged. If so, press
EXIT
to return to the
Test
pattern
menu and continue with Blue on green.
If not yet correctly converged, check the distance between lines 5 and 6 of the red
pattern and the distance between lines 5 and 6 of the green lines.
Two possibilities :
1) distance between red lines is smaller than distance between green lines.
Turn screw 5 and 6 clockwise until distance between lines 5 and 6 is the same for the
red and green lines.
2) distance between red lines is greater than distance between green lines.
Turn screw 5 and 6 counter clockwise until distance between lines 5 and 6 is the same
for the red and green lines.
Due to this movement the lines 1, 2, 3 and 4 may be out of convergence. Repeat the
above mentioned steps for the respective lines.
If all lines are correctly converged, press
EXIT
to return to the
Test pattern
menu.
4
1
6
5
3
2
4
1
6
5
3
2