Barco R9001070 - Manual (Page 106)

Service Mode
5975696 BARCODATA 2100 140798 12-13
Service Mode
5975696 BARCODATA 2100 140798 12-13
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
CHANGE LANGUAGE
75 Ω TERMINATION
DIMMING
I2C DIAGNOSIS
MORE ...
DIMMING
010 0 50
Dimming
(for lamps with order numbers R9829510 and R9829740)
Highlights 'Dimming' by pushing the control disk up or down in the
Service menu and press ENTER to select.
The projector starts alsways with full lamp power but it can be
reduced to 50% of its maximum power in 8 steps.
Push the control disk to the left or to the right to reduce or increase
the lamp power. Press EXIT when the desired lamp power is installed.
The Service menu returns on the screen.
Due to start up conditions of the lamp (always full power), the Dimming
setting is not saved when the projector is powered down.
Lamp Drive Mode
(for lamps with order number R9829600)
Highlight 'Lamp drive mode' by pushing the control disk up or
down in the Service menu and press ENTER to select.
The projector always starts in NORMAL MODE.
Highlight the desired mode by pushing the control disk up or down
and press ENTER to select.
Due to start up conditions of the lamp (always normal mode), the
Lamp drive mode is not saved when the projector is powered
down.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
CHANGE LANGUAGE
75 Ω TERMINATION
LAMP DRIVE MODE
I2C DIAGNOSIS
MORE ... LAMP DRIVE MODE
ECONOMIC
NORMAL
Select with ê or é
<ENTER> to accept
<EXIT> to return
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
CHANGE LANGUAGE
75 Ω TERMINATION
DIMMING
I2C DIAGNOSIS
MORE ...
DIMMING
010 0 50
Dimming
(for lamps with order numbers R9829510 and R9829740)
Highlights 'Dimming' by pushing the control disk up or down in the
Service menu and press ENTER to select.
The projector starts alsways with full lamp power but it can be
reduced to 50% of its maximum power in 8 steps.
Push the control disk to the left or to the right to reduce or increase
the lamp power. Press EXIT when the desired lamp power is installed.
The Service menu returns on the screen.
Due to start up conditions of the lamp (always full power), the Dimming
setting is not saved when the projector is powered down.
Lamp Drive Mode
(for lamps with order number R9829600)
Highlight 'Lamp drive mode' by pushing the control disk up or
down in the Service menu and press ENTER to select.
The projector always starts in NORMAL MODE.
Highlight the desired mode by pushing the control disk up or down
and press ENTER to select.
Due to start up conditions of the lamp (always normal mode), the
Lamp drive mode is not saved when the projector is powered
down.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
CHANGE LANGUAGE
75 Ω TERMINATION
LAMP DRIVE MODE
I2C DIAGNOSIS
MORE ... LAMP DRIVE MODE
ECONOMIC
NORMAL
Select with ê or é
<ENTER> to accept
<EXIT> to return