Barco R9001070 - Manual (Page 34)

Installation Set Up
Installation Set Up
5975696 BARCODATA 2100 140798 4-3
4-3 5975696 BARCODATA 2100 140798
To change the Configuration, enter the adjustment mode by pushing ADJUST or ENTER.
Highlight Installation by pushing the control disk up or down and press ENTER to select.
The installation menu will be displayed.
ENTER displays the Installation menu.
EXIT returns to operational mode.
Select with é or ê
then <ENTER>
<EXIT> to return.
Highlight Configuration by pushing the control disk up or down and press ENTER to
select. The configuration menu will be displayed.
ENTER displays the Configuration menu.
EXIT returns to the path selection menu.
ADJUST retuns to operational mode.
The actual selected configuration will be highlighted.
Push the control disk up or down to select the corresponding configuration with
regard to the projector environment. Press ENTER to confirm your selection.
ENTER to confirm the selection.
EXIT returns to the installation menu.
ADJUST retuns to operational mode. Select with é or ê
then <ENTER>
<EXIT> to return.
Select with é or ê
then <ENTER>
<EXIT> to return.
CONFIGURATION
FRONT/TABLE
FRONT/CEILING
REAR/TABLE
REAR/CEILING
INSTALLATION
CONFIGURATION
INTERNAL PATTERNS
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
To change the Configuration, enter the adjustment mode by pushing ADJUST or ENTER.
Highlight Installation by pushing the control stick forward or backward and press
ENTER to select. The installation menu will be displayed.
ENTER displays the Installation menu.
EXIT returns to operational mode.
Highlight Configuration by pushing the control stick
Select with é or ê
then <ENTER>
<EXIT> to return.
forward or backward and press ENTER to select. The configuration menu will be
displayed.
ENTER displays the Configuration menu.
EXIT returns to the path selection menu.
ADJUST retuns to operational mode.
The actual selected configuration will be highlighted.
Push the control stick forward or backward to select the corresponding configuration
with regard to the projector environment. Press ENTER to confirm your selection.
ENTER to confirm the selection.
EXIT returns to the installation menu.
ADJUST retuns to operational mode. Select with é or ê
then <ENTER>
<EXIT> to return.
Select with é or ê
then <ENTER>
<EXIT> to return.
CONFIGURATION
FRONT/TABLE
FRONT/CEILING
REAR/TABLE
REAR/CEILING
INSTALLATION
CONFIGURATION
INTERNAL PATTERNS
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01