Unpacking & dimensions, Battery installation in the rcu – Barco R9001070 User Manual
Page 24
Unpacking & Dimensions
2-4
5975696 BARCODATA 2100 140798
Unpacking & Dimensions
2-4
5975696 BARCODATA 2100 140798
310a.DRW
Battery Installation in the RCU.
A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power
cord. Before using the RCU, start first the battery installation procedure.
Remove the battery cover on the backside of the remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery in the lower compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note : projector address has to be programmed on the RCU before using the RCU (see chapter
'Controlling').
fig.1
fig.2
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this manual.
Contact
plate
Battery
310a.DRW
Battery Installation in the RCU.
A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power
cord. Before using the RCU, start first the battery installation procedure.
Remove the battery cover on the backside of the remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery in the lower compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note : projector address has to be programmed on the RCU before using the RCU (see chapter
'Controlling').
fig.1
fig.2
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this manual.
Contact
plate
Battery