Rockwell Automation 160 160SSC CopyCat Keypad - Manual (Page 10)

1-6 Introduction
Display Description
The keypad has a 2-row by 16-column liquid crystal display (LCD) which shows
parameter names and numbers, parameter values, fault codes, and other messages.
If the drive faults, the display will indicate the presence of the fault, and the fault
code and name will be displayed. Pressing the Up or Down arrow, Enter, or Escape
key will return the keypad to Display mode. If the fault condition is reset without
pressing one of these keys, the display will return to the display or program
parameter that was selected prior to the occurrence of the fault.
Drive Status Indicators
The keypad has four status LEDs which serve as mode and direction indicators.
LED Functions Table 1.B
➊ When the PROGRAM and LOAD LEDs are both off, the keypad is in Display mode.
Name Status Description
PROGRAM On The keypad is in Program mode. ➊
Flashing The keypad is in Edit mode.
LOAD On The keypad is in Load mode. ➊
RUN On The drive is running.
REVERSE On If keypad control is selected (P46 = 2 or 6), this LED will turn on
if the direction commanded by the keypad is reverse.
If keypad control is not selected, this LED will turn on when the
drive is running reverse.
Flashing The direction LED will flash when the drive is commanded to
change direction. When the motor is turning in the new direction
the LED will stop flashing.