Rockwell Automation 160 160SSC CopyCat Keypad - Manual (Page 21)

How to Program the Drive 2-9
Important: Stopping a Load operation can produce a Drive Configuration File
with undesirable parameter combinations. Correct the problems
and complete Loading or restore parameters to the original values
before Starting the drive.
Rename a Drive Configuration File
By default, files that are loaded to the CopyCat Keypad are assigned a name that
contains the drive voltage, horsepower, firmware revision number, and model.
The following example shows a file that was loaded from a 230 volt,
0.75 horsepower Analog Signal Follower model drive using revision 7.04 firmware.
To rename a drive configuration file:
1. Press the Escape key until the Load LED lights.
In Load mode, the Load Menu is displayed.
There are three Load Menu options:
• TO Drive
• FROM Drive
• DEFINE Names
2. Press the Up or Down arrow key to display the Load Menu DEFINE Names
option.
3. Press the Enter key to select the option.
“DEFINE Names” and the first drive configuration file in the directory is
displayed. For example:
4. Press the Up or Down arrow key to scroll to the drive configuration file that
you want to rename.
5. Press the Enter key to place the cursor at the first character of the file name.