Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 27)

A–B
4 Chapter
4–1
Using The Software
This chapter provides general instructions on starting the Powermonitor
Software, establishing communications with a remote device, using the
Powermonitor Software menu system, and using the on–screen help feature.
To Run The Software From The Hard Drive
If the user has performed the hard drive installation procedure given in
Chapter 3, the Powermonitor Software may be run from the hard drive by
entering the following commands:
CD \SP <Enter>
SP <Enter>
After a moment, the Powermonitor Software TITLE screen will appear on
the monitor (see Figure 4.1 on Page 4–2), followed by the Powermonitor
Software CONNECTION SCREEN.
To Run The Software From The Floppy Diskette
!
ATTENTION: The floppy diskette used to run the Powermonitor
Software must not be write protected, since the Powermonitor
Software saves the last CONNECTION screen data entered by
the user, and the Powermonitor Software PASSWORD to the
currently selected drive when the user exits to DOS.
If the user wishes to run the Powermonitor Software from the floppy
diskette, enter the following commands:
A: <Enter>
SP <Enter>
After a moment, the TITLE screen will appear on the computer monitor
(see Figure 4.1 on Page 4–2), followed by the CONNECTION SCREEN.
Chapter Objectives
Startup