Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 39)

A–B
5 Chapter
5–1
Powermonitor Data Display And Configuration
This chapter describes the steps necessary to display real–time and logged
data from a Powermonitor, and how to configure the operating parameters of
the device.
Data Display Formats
Following connection to a Powermonitor (as described in Chapter 4) the
system operator can display data from that device by selecting the desired
data screen from the MAIN MENU. These include:
a. REAL–TIME
b. EVENT LOG
c. SNAPSHOT
d. STATUS (incl. Relay Status, Status Inputs, and Setpoint Status)
e. MIN/MAX
Displaying Device Data
To display data from a particular device:
1. Connect with the Powermonitor as described in Chapter 4 (if not
previously performed).
2. Return to the MAIN MENU by pressing <Esc>, select the desired data
screen using the cursor keys, and press <Enter>.
Alternately, the operator can use the shortcut keys to view data screens
directly, rather than using the MAIN MENU. Shortcut key functions are
listed in the HELP line at the bottom of the screen.
The most recent data for the selected device screen should appear almost
immediately.
Important: If the site is accessed via a modem that is not presently
connected, a series of messages will appear at the bottom of the screen
indicating modem connection status. It may take 30 seconds to establish
connection with the site before updated data will appear on the
Powermonitor.
Chapter Objectives
Displaying Single Device Data