Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 43)

Chapter 5
Powermonitor Data Display and Configuration
5–5
Data display screens for the Powermonitor include:
REAL–TIME
EVENT LOG
SNAPSHOT
STATUS
MIN/MAX
Configuration screens for the Powermonitor Software include:
DEVICE SETUP
SETPOINT/RELAY SETUP
Additional device functions include:
CLEAR kWH
CLEAR kVAH
CLEAR kVARH
CLEAR S1 COUNTER
CLEAR MIN/MAX
CHANGE PASSWORD
All device data display screens, configuration screens and functions can be
accessed via the MAIN MENU.
For the Powermonitor, the operator must first select the CLEAR HOURS
option to access the CLEAR kWH, CLEAR kVARH, or kVAH functions for
the Powermonitor (Refer to Figure 5.3 on Page 5–5). The Powermonitor
Software will then prompt the operator for the password and then to specify
which total is to be cleared. After entering this menu selection and
successfully entering the SP software password, the prompt “ CLEAR ALL
HRS, kWH, kVARH, OR kVAH– (0/1/2/3) ?” will be displayed. By entering
the value of 0, this will clear the kWH, kVARH, and kVAH counters
simultaneously. NOTE: The kVAH option is displayed and cleared for only
those powermonitor units with firmware version 0.7 or later. The Main Menu
screen also provides an additional CLEAR S1 COUNTER function.
The RELAY CONTROL option of the MAIN MENU is described in
Chapter 6, ‘‘Manual Control of Powermonitor Internal Relays.”
Data Display and Configuration
Screens
Main Menu