Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 56)

Chapter 5
Powermonitor Data Display and Configuration
5–18
Upon entering a screen, the user is requested to enter the Powermonitor
Software password. Failure to enter the correct password will cause
Powermonitor Software to exit the CLEAR screen and return to the MAIN
MENU screen. If the password is correct, the operator is asked to confirm
the selection of the parameter to be cleared. The Powermonitor Software
displays a prompt similar to the following:
CONFIRMING CLEARING
OF kWH – (Y/N)?
If the user responds with a “Y”, then the Powermonitor Software will display
an appropriate message. If the user responds with an “N”, then
Powermonitor Software will display the message:
CLEARING OPERATION ABORTED
Upon completion of the CLEAR function, the Powermonitor Software will
return to the MAIN MENU screen.
The option CLEAR HOURS provides three sub–options to choose from,
following the entry of the correct password. The operator must then enter the
number “1” to clear kWH or “2” to clear the kVARH, or ‘‘3” to clear kVAH.
As above, the Powermonitor Software asks for confirmation to complete the
operation.
After entering this menu selection and successfully entering the SP software
password, the prompt “CLEAR ALL HRS, kWH, kVARH, OR kVAH –
(0/1/2/3) ?” will be displayed. By entering the value of 0, this will clear the
kWH, kVARH, and kVAH counters simultaneously.
NOTE: The kVAH option is displayed and cleared for only those
powermonitor units with firmware version 0.7 or later.