Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 41)

Chapter 5
Powermonitor Data Display and Configuration
5–3
If additional data is available, a message line at the bottom of the data screen
will tell the operator which key functions to use to view the data.
To Exit From Any Data Display Screen
To exit from any screen, the operator can either press the <Esc> key to return
to the MAIN MENU, or press one of the shortcut keys to display another
data screen directly.
The Powermonitor Software gives the system operator the ability to remotely
view or reconfigure the DEVICE SETUP and SETPOINT/RELAY SETUP
parameters of a Powermonitor from the Master Display Station.
Displaying The Setup Or Setpoint Parameters Of Any Devices
All device configuration functions are accessed from the MAIN MENU. To
display data from a particular device:
1. Connect with the desired Powermonitor as described in Chapter 4.
2. Return to the MAIN MENU.
3. Place the cursor onto the DEVICE SETUP or SETPOINT/RELAY
SETUP field for the desired device (depending on which set of
parameters you wish to view and/or configure) and press the <Enter> key.
An example of a Powermonitor configuration screen is provided in
Figure 5.2.
Figure 5.2
Example of Powermonitor Configuration Screen
Configuring Powermonitors