Rockwell Automation 1395 Node Adapter Board - Manual (Page 51)

4 Chapter
4-1
Installation
Introduction This chapter is a detailed step-by-step procedure for the proper installation
of the Bulletin 1395 Node Adapter Board. It also contains electrical and
environmental specifications. Procedures performed in this chapter include:
S Verification of proper unpacking and inspection
S Verification of proper mounting
S Verification of proper wiring
Receiving It is your responsibility to thoroughly inspect the equipment before
accepting shipment from the freight company. You must take the
responsibility for noting any damage. Do Not accept shipment before
checking all items received against the purchase order, and noting any
missing or damaged items on the freight bill.
If any concealed damage is found later during unpacking, it is your
responsibility to notify the freight agent. Leave the shipping container
intact and request that the freight agent make a visual inspection of the
shipment.
Unpacking & Inspection Remove all packing material from around the board, including the
anti-static bag. The Node Adapter Board is a static sensitive device, and
special precautions should be taken while handling the board. The circuit
board can be damaged by Electrostatic Discharge. If personnel will make
contact with an ESD sensitive component during installation, they must be
grounded. Grounding should be accomplished with a wrist strap which is
connected to an approved ground.
If the board will not be installed when it is unpacked, it should be stored in
a clean dry place in the anti-static bag. The storage temperature must be
between 0
°C (32°F) and +60°C (140°F) with a maximum humidity of 95%
non-condensing, to guard against damage to temperature sensitive
components of the drive.
Mounting The Node Adapter Board is mounted on the front of the the swing out
panel. Two possible adapter board mounting positions are provided,
depending on the port that the board will be connected. When looking at
the mounting positions from the front, the right position corresponds to
Port B and the left to Port A. The port used is dependent on the specific
application of the drive.