Rockwell Automation 1395 Node Adapter Board - Manual (Page 52)

Chapter 4
Installation
4-2
After determining which port the Node Adapter Board will be connected
to, mount the board, using the five (5) panel screws and one (1) phillips
head screw supplied (Figure 4.1).
Figure 4.1
Configuration Overview
AB0733A
J2 J3
*
*
J1 J1
*
*
Connections The 60 pin ribbon cable connector (J1) located on the Node Adapter Board
(see Figure 4.1) provides a means of connecting the board to the Bulletin
1395 Main Control Board port connector (J6 or J7). The port connector
used is determined by the port and the physical location of the Node
Adapter Board. Main Control Board Connector J6 corresponds to Port B
and J7 to Port A.
The Remote I/O cable from the PLC is connected directly to the Node
Adapter Board at connector J2 (see Figure 4.2). If the PLC Controller is
controlling only one drive, terminals 1–3 are used. If the PLC Controller is
used to control several drives, terminals 1–3 are connected to the upstream
drive (or PLC Controller if the drive is the first in the network) and
terminals 4–6 are connected to the downstream drive. Refer to the
following procedure and Figure 4.2 and Figure 4.3.
3. 1. Connect the 60 lead ribbon cable from J1 on the Node Adapter
Board to the corresponding connector on the Main Control Board.