Rockwell Automation 1746-XXXX SLC 500 4-Channel Analog I/O Modules User Manual - Manual (Page 29)

Publication 1746-UM005B-EN-P - June 2004
Installing and Wiring Your Analog Module 3-7
Removing the Analog Module Terminal Block
To remove the terminal block, grasp it on the top and bottom and pull
outward and down.
1. Verify that all switches are set correctly for the application.
ATTENTION
Never install, remove, or wire modules with power
applied to the chassis. Also, do not expose analog
modules to surfaces or other areas that may typically
hold an electrostatic charge. Electrostatic charges can
destroy the analog circuitry.
IMPORTANT
The potentiometer sets the voltage during factory
calibration to 2.5 volts. It is set and sealed at the
factory and does not require any adjustments.
ATTENTION
Care should be taken to avoid connecting a voltage
source to a channel configured for a current input.
SLOT ____ RACK ____
MODULE _____