Panel/wall mounting, Set the node address, Wire the adapter – Rockwell Automation 1440-ACNR XM ControlNet Adapter User Manual
Page 15: Set the node address wire the adapter
Publication ICM-UM001C-EN-E - March 2013
15
Install the Adapter Chapter 2
Panel/Wall Mounting
If mounting the adapter to a panel or wall, refer to publication 1794-5.13,
"Panel Mounting Kit, Cat. No. 1794-NM1."
Set the Node Address
Set the node address using the 2-position pushwheel switch. Valid settings
range from 01 to 99.
Press either the + or - buttons to change the number.
Wire the Adapter
Follow these steps to wire the adapter.
2 5
Network
Address
Switch
ATTENTION
Do not wire more than two conductors on any single terminal.
WARNING
If you connect or disconnect wiring while the field-side power
is on, an electrical arc can occur. This could cause an explosion
in hazardous location installations. Be sure that power is
removed or the area is nonhazardous before proceeding.