Metrohm 855 Robotic Titrosampler - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
855 Robotic Titrosampler ￭￭￭￭￭￭￭￭ 15
For Windows Vista: The instrument is recognized and the installation
assistant for the driver is started automatically. Select the option "Find
and install driver software". Agree to all subsequent requests. The
installation assistant will be exited automatically.
Note
The plug on the instrument end of the 6.2151.000 controller cable is
protected with an anti-pull device to prevent the cable from being pulled
out accidentally. If you wish to pull out the plug, then you must first retract
the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC software
The instrument must be registered in the configuration of your PC software.
Once that has been done, you can then configure it according to your
requirements. Proceed as follows:
1 Setting up the instrument
￭ Start up the PC software.
The instrument is recognized automatically. The configuration dia-
log for the instrument is displayed.
￭ Make configuration settings for the instrument and its connectors.
More detailed information concerning the configuration of the instu-
ment can be found in the documentation for the respective PC soft-
ware.
3.4 Connecting the Swing Head
Take care to ensure that the Swing Head is connected before the instrument
is started up. Check the connection cable.
The connection socket (Mini DIN) for the Swing Head drive is each located
on the rear of the tower next to the stirrer connector.
Figure 9 Connecting Swing Head