Metrohm 855 Robotic Titrosampler - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ Table of contents
855 Robotic Titrosampler ￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 The 855 Robotic Titrosampler in the Titrando sys-
tem ......................................................................................... 1
1.2 Instrument description ......................................................... 2
1.2.1 Model versions ........................................................................ 3
1.2.2 Instrument components .......................................................... 3
1.2.3 Intended use ........................................................................... 4
1.3 About the documentation ................................................... 4
1.3.1 Symbols and conventions ........................................................ 4
1.4 Safety instructions ................................................................ 5
1.4.1 General notes on safety ........................................................... 5
1.4.2 Electrical safety ........................................................................ 5
1.4.3 Tubing and capillary connections ............................................. 6
1.4.4 Personnel safety ...................................................................... 7
1.4.5 Flammable solvents and chemicals ........................................... 8
1.4.6 Recycling and disposal ............................................................. 8
2 Overview of the instrument 9
2.1 Front and rear ....................................................................... 9
2.2 Rear panel ........................................................................... 11
2.3 Sensor connectors .............................................................. 11
2.4 Sample racks ....................................................................... 12
3 Installation 13
3.1 Setting up the instrument .................................................. 13
3.1.1 Packaging .............................................................................. 13
3.1.2 Checks .................................................................................. 13
3.1.3 Location ................................................................................ 13
3.2 Preparing the Sample Processor ....................................... 13
3.2.1 Connecting a mains cable ...................................................... 13
3.3 Connecting a computer ................................................... 14
3.4 Connecting the Swing Head .............................................. 15
3.5 Configuring the robotic arm .............................................. 16
3.6 Mounting the robotic arm ................................................. 18
3.7 Robotic arms with beaker sensor ..................................... 20
3.8 Installing rinsing and aspiration equipment .................... 21
3.9 Guide chain for cables and tubing .................................... 24