Metrohm 855 Robotic Titrosampler - Manual (Page 45)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
855 Robotic Titrosampler ￭￭￭￭￭￭￭￭ 37
The rack is moved into starting position. The magnet code of the rack
is read by the instrument during this process. The white arrow in figure
30 indicates the position of the magnet holder. The six-digit magnet
code is used to identify the rack type. The sample positions and any
special positions on the rack are defined along with the rack type.
3.18 Mounting the safety shield
Warning
It is imperative that the safety shield be installed before the first time the
855 Robotic Titrosampler is used. The device is not permitted to be oper-
ated without a safety shield.
1
2
3
Figure 31 Mount the safety shield
Proceed as follows:
1 Loosen the knurled screws on both sides of the tower.
2 Move the safety shield into position, starting from the top. Observe
the corresponding illustration.
3 Fix the safety shield in place with the knurled screws.