Metrohm 886 Prof.Thermostat/Reactor User Manual
Page 21
■■■■■■■■■■■■■■■■■■■■■■
3 Installation
886 Professional Thermostat (2.886.0110) / 886 Professional Reactor (2.896.0210)
■■■■■■■■
13
To remove the base tray, you need the 6.2621.100 hexagon key 3 mm.
1
2
3
1 Tilt the instrument sideways and lay it down flat.
2 Loosen the cylinder screws with the 3 mm hexagon key and remove
them and their washers.
3 Remove base tray.
The base tray must always be mounted under the lowermost instrument
of the stack. Proceed as follows:
Mounting the base tray
Before you can mount the base tray, the following preconditions must be
met:
■
The instrument is switched off.
■
The bottle holder is cleared.
■
All connections at the rear of the instrument are disconnected.
■
There are no loose parts in the instrument.
■
The instrument is lying on it side, and the bottom surface is visible.
To mount the base tray, you need the 3 mm hexagon key (6.2621.100).