Canon IMAGE RUNNER 5075 - Manual (Page 109)

Settings Menu 3-41
3
Pr
inter Settings Menu
Q Density
1 to 5; 3 *
This setting enables you to adjust the number density and has 5 levels you can
adjust, with level '3' (middle level) being the default setting. Selecting '1' makes
the number lighter, and selecting '5' makes it darker.
NOTE
This function is only available if 'Copy Set Numbering' is set to [On].
Q Number Position Vertical/Number Position Horizontal
-5/16 to +5/16 inches (in increments of 1/16 inches); 0 * inches
The position of the copy numbers specified with 'Print Position' can be finely
adjusted by offsetting them in the horizontal or vertical directions. The adjustment
can be made from -5/16" (-8 mm) through +5/16" (+8 mm) in increments of 1/16"
(1 mm).
You can increase or decrease the setting value to adjust the print position of the
copy numbers, as described below.
Number Position Vertical: Increasing the setting value moves the print position
in the downward direction of the paper. Decreasing the setting value moves the
print position in the upward direction of the paper.
Number Position Horizontal: Increasing the setting value moves the print
position to the right. Decreasing the setting value moves the print position to the
left.
IMPORTANT
Please note that if the print position is adjusted to place the digits of the copy
numbers outside the printable area, the portion outside the printable area is not
printed.
NOTE
š This setting is only effective for the print position of copy numbers. When adjusting
print position (other than the copy numbers), perform the setting with 'Offset Short
Edge/Offset Long Edge'. (See p. 3-19 to p. 3-20.)
š This function is only available if 'Copy Set Numbering' is set to [On].
00001 00001
00001 00001
Horizontal "+" direction
Vertical "+" direction
Original print position of copy numbers