B&G H5000 Pilot Computer - Manual (Page 28)

28 | Operation | H5000 Operation Manual
Race timer
The race timer can be used to countdown to zero from a specifi ed time, ideal for counting
down to a race start. It can also be used to count up from zero to record the elapsed time.
The timer can be started at any time by selecting Start Timer from the timer setup menu. If
the start value is set to zero (00:00) when the timer is started the timer will begin counting up,
recording the elapsed time.
¼ Note: The timer is shared between all displays on the network. All timer values are
synchronized.
¼ Note: The timer set value is in Hours : Minutes (hh:mm), the timer counter will show Minutes :
Seconds (mm:ss) with the hours shown in the top right hand corner of the display.
Countdown timer
To count down to a race start, a time value can be set in the Set start value fi eld in the Race
Timer setup menu.
Set start value
1 Select the Start Time fi eld.
2 Use the UP & DOWN keys to set the desired number
3 Press the the ENTER key to move to each consecutive number.
4 Press the PAGE key to exit the number edit fi eld.
5 Once complete select OK to confi rm.
¼ Note: Selecting Cancel or navigating away using the PAGE key will lose any changed settings.
When a time is present in the start value fi eld the timer will begin to count down from that
number when the timer is started. Once the time reaches zero it will begin counting up
recording the elapsed time.
MENU
x2